|
|
| |
| |
|
| TURN MOTOR INSTRUCTIONS |
|
|
|
|
|
| READ INSTRUCTIONS BEFORE USING PRODUCT TO AVOID COMPROMISING WARRANTY OF UNIT |
The design of the turntables is sound and safe. We advise users to turn all switches on the unit "OFF" or disconnect unit from the electrical supply when there is no one present in the room.
DO NOT USE FLAMMABLE MATERIALS WITH THIS PRODUCT!!! DO NOT USE ANY METALLIC TINSEL OR GARLAND WHICH CAN GET PULLED UNDER THE TOP AS IT CAN BE A FIRE HAZARD AND CAUSE DAMAGE TO TURNTABLE.
Make sure all wiring coming from the electrical outlet on top is pulled tight with no slack in the cord as it can become wound up under the top causing damage to the brushes.
DO NOT OVERLOAD THE WEIGHT OR ELECTRICAL CAPACITY OF THE TURNTABLE.
• Maximum 5 amp capacity (approximately 1500 miniature lights).
• Specifications: 125 volts AC, 250 pound capacity when center loaded.
| |
ATTENTION: FAILURE TO FOLLOW DIRECTIONS WILL VOID WARRANTY!!! |
|
TO REMOVE TOP ON ALL COUNTER AND FLOOR MODEL TURNTABLES
Disconnect electrical supply. Due to a recurring problem with the previous top attachments there has been a significant change in the way they are attached. They are now attached with a set screw. To remove the top, one will need a 3/16" hex wrench with an extra long shank. Loosen the screw by turning it in a counterclockwise direction. To remove top, lift up and gently twist in one direction. (DO NOT JERK AS THIS MAY DAMAGE A TOOTH ON THE PHENOLIC GEAR.)
TO INSTALL TOP PLATE
Disconnect electrical supply. Place turntable on floor. Stand on edge of bottom plate with one foot on each side of the plate. Place center hole in top plate on shaft. With both hands, firmly push down on the top while keeping the set screw aligned with the flat area on the center shaft. Make sure the plate is pushed all the way down in order for the brushes to make contact. Tighten the set screw with a 3/16" hex wrench with an extra long shank by turning set screw in a clockwise direction. Check outlet for electrical contact after reinstalling the top plate.
SECURE THE BASE OF THE TREE TO THE TOP OF THE TURNTABLE
When using the turntable on a carpeted floor or when load extends outward in excess of 12" on all sides it will be necessary to place a 24" square or round piece of 3/4" plywood under the turntable to keep it from tipping back and forth.
WE RECOMMEND THAT YOU USE ONLY ARTIFICIAL CHRISTMAS TREES NOT TO EXCEED A MAXIMUM OF 8 FEET TALL, 250 POUNDS TOTAL DECORATED WEIGHT.
DO NOT ATTEMPT TO MAKE INTERNAL REPAIRS; THIS WILL VOID THE WARRANTY.
SEND BACK TO MANUFACTURER.
|
|
|
| |
|
| |
|
| |
|
|
|
|
|
